Abstract

Statement of problem
Whether single crowns produced by computer-aided design and computer-aided manufacturing (CAD-CAM) have an internal fit comparable to crowns made by lost-wax metal casting technique is unknown.

Purpose
The purpose of this in vitro study was to compare the internal fit of single crowns produced with the lost-wax and metal casting technique with that of single crowns produced with the CAD-CAM technique.

Material and methods
The internal fit of 5 groups of single crowns produced with the CAD-CAM technique was compared with that of single crowns produced in cobalt-chromium with the conventional lost-wax and metal casting technique. Comparison was performed using the triplescanprotocol; scans of the master model, the crown on the master model, and the intaglio ofthe crown were superimposed and analyzed with computer software. The 5 groups were milled presintered zirconia, milled hot isostatic pressed zirconia, milled lithium disilicate, milled cobaltchromium, and laser-sintered cobalt-chromium.

Results
The cement space in both the mesiodistal and buccopalatal directions was statistically smaller (P<.05) for crowns made by the conventional lost-wax and metal casting technique compared with that of crowns produced by the CAD-CAM technique.

Conclusions
Single crowns made using the conventional lost-wax and metal casting technique have better internal fit than crowns produced using the CAD-CAM technique.


Reference
Internal fit of single crowns produced by CAD/CAM and lost-wax metal casting technique assessed by the triple-scan protocol
Dahl BE, Rønold HJ, Dahl JE.
The Journal of prosthetic dentistry 2016. [Print].

print